Get A Quote

We have a great track record of helping our customers solve demanding design and production challenges. We’d like to help you. Just call us at 508-222-0897 or fill out and submit the form below so that we may contact you.

Name(Required)

First Last

Job Title(Required)

Company Name(Required)

Email(Required)

Enter Email Confirm Email

Phone Number

Street Address

City

State/Region

Postal Code

Country

Comments

Upload Drawing

If uploading more than 1 drawing please gather into a single directory/folder and Zip before uploading.

Max. file size: 50 MB.

Run Quantity(Required)

Our typical production runs start at about 5,000 pieces or so, but there are exceptions. Keep in mind that we manufacture using custom-built, permanent tooling which must be purchased up front. In most cases, small volumes do not justify the cost of this tooling which could run from several thousand dollars to upwards of fifty thousand or more, depending on the complexity of the part and precision required.

Material Thickness (inches)(Required)

Larson is a medium-to-high volume stamper of automotive and industrial hardware, and deep drawn shells and cylinders. We work primarily with material gages that are found in those types of applications. Although we can work in heavier materials under certain conditions, our equipment is geared to process materials from. 015” (.38mm) to .180” (4.6mm), and that is where we operate most efficiently. Please enter a number between 0.015 and 0.180.

Please enter a number from 0.015 to 0.180.

Substrate(Required)

Note: Larson does not stamp on non-metallic materials.

CAPTCHA

Comments

This field is for validation purposes and should be left unchanged.